Smart Punch SPu20 module

Smart Punch SPu20 Overview

The Smart Punch SPu20 manual punching unit allows getting a chip, a contact plate or a fingerprint sensor out of a film, one by one. The component can then be manually embedded into a card cavity using the SI20.

The SPu20 manual punching system is supplied with a die & punch tool designed to fit with the component to punch.

The die & punch tool can be replaced with another set to support another component design, forinstance a chip (6 or 8 pins) or a contact plate.

The SPu20 is not needed for IDEX sensors as they can be easily removed manually from the paper-line.

The Smart Punch SPu20 is made in France.

Equipment overview for milling, lamination, embedding, personalization.

Alternative solutions for lamination: 1)Use an OEM laminator supplied by STS. 2)Use your existing laminator, or a laminator from another brand. 3)Outsource lamination to STS

Alternative solutions for card milling: 1)If the sensor is in the ISO position when the card is turned 180°, then an existing milling machine can be used (by turning all cards by 180°). 2)Use an OEM manual milling system supplied by STS, able to mill in various positions. 3) If a MPR5000 or MPR5800* with a milling module is available, then STS can adapt it to be able milling in any position .

Embedding with the SI20 semi-automatic presser heads system: The SI20 allows testing/tuning a process by manually embedding sensors, chips or contact plates on test cards – before producing cards in volume with the SI700.

Smart Punch SPu20 Manual punching system: Use the Manual Punching system Smart Punch 20 (SPu20) to get a sensor from the film .